LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2001 >> Golf GL, 2.0 B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (1.8L - Fuel Injection & Ignition, Engine Code(S): AWD) >> 01 On Board Diagnostic (OBD) >> Diagnostic Trouble Code (DTC) table: SAE P0-Codes >> Diagnostic Trouble Code (DTC) table: SAE P0-Codes

Diagnostic Trouble Code (DTC) table: SAE P0-Codes

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • The DTC table is organized according to SAE and VAG diagnostic trouble codes.
  • EPC relevant malfunctions are also indicated by the MIL for electric accelerator mechanism (EPC warning lamp).
  • Further information on the malfunction types (e.g. "Open/Short circuit to Ground)

    • Refer to Scan Tool operating instructions

  • If components are designated as faulty: First check wiring and harness connectors for these components as well as Ground (GND) wiring for the system according to wiring diagram. Do not replace component unless there are no malfunctions found here. This is particularly valid when malfunctions are displayed as "sporadically occurring" (SP).
  • Erase DTC memory after repairing malfunction. Refer to DTC memory of Engine Control Module (ECM), checking (scan tool function 02) and erasing (scan tool function 05)  .

Example printout on VAG1551 printer: 

16497 P0113 035 

Intake Air Temperature (IAT) sensor -G42- 

Signal too large 

sporadic malfunction 

Explanation: 

Explanation of SAE trouble codes 

System type 

Norm-Code: 

Repair group 

scientia non olet · About LEMON Manuals