Camshaft, removing and installing: Installing

WARNING: This page is about a different variant/trim than selected.

NOTE:

When installing the camshaft, the cam lobes for cylinder 1 must point upward.

Fig 1: Installed Position Of Camshaft Bearing Caps

GW00000102

Courtesy of VOLKSWAGEN UNITED STATES, INC.

When installing, make sure the bearing cap is centrally positioned. Before installing, set bearing cap in place and determine installation position.

Oil running surfaces of camshaft.
Tighten bearing caps 2 and 4 alternately and diagonally to 20 Nm.
Install bearing cap 5, 1 and 3 and tighten to 20 Nm.
Install bearing cap 5 into place by lightly tapping on end face of camshaft.

Set camshaft sprocket in place.
Toothed belt, installing, tensioning. Refer to Toothed belt, removing, installing and tensioning .

NOTE:

After installing new valve lifters, the engine may not be started for approx. 30 minutes. The hydraulic equalization elements must seat themselves (otherwise the valves will crash into the pistons).