Checking activation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Do not touch the Ignition Coil connecting parts or adapter cables during the following test.
- Disable the power supply to the Fuel Injectors N30, N31, N32, N33, by removing Fuse 29 (on fuse panel B) from the fuse holder SB29, in the E-box, plenum chamber.
- Using a diode test lamp , check the Ignition Coil electrical harness connector terminals 1 to 4 and 3 to 4 for voltage.
- Operate the starter.
The LED should flicker.
- Switch the ignition off.
If the LED flickers and the voltage was OK:
- Replace the faulty Ignition Coil N152 .Refer to Ignition/Glow plug, Rep. Group. 28.
If the LED does not flicker: