Over-center spring, removing and installing: Installing

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Pull clutch pedal into passenger compartment.

Fig 1: Installing Over-Center Spring Together With Assembly Device T10111 Into Support

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Insert over-center spring together with assembly clamp T10111 upward in direction of - arrow A - into mounting bracket and turn in direction of - arrow B - while doing so.

Fig 2: Identifying Rear Support & Clutch Pedal Bearing Tab

Courtesy of VOLKSWAGEN UNITED STATES, INC.

First, install over-center spring in bearing - arrow A - at rear.
Press clutch pedal to cross panel until over-center spring makes contact at mounting pin - arrow B - of clutch pedal.
Bring clutch pedal into rest position, remove assembly clamp while doing so.
Install trim under steering column. → 68 - INTERIOR EQUIPMENT .