Transmission Housing And Selector Mechanism, Removing And Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
1 - Countersunk head bolt, 25 Nm
2 - Flanged shaft with spring
- Removing and installing. Refer to Oil seal for left flanged shaft, replacing
- Assembling. Refer to Differential, disassembling and assembling
3 - Back-up light switch, 20 Nm
4 - Oil seal
- Always replace
5 - Oil drain plug, 30 Nm
- Always replace
6 - Oil seal
- Always replace
7 - Cover plate
8 - Hex bolt, 20 Nm
- Always replace
9 - Hex bolt, 20 Nm
- For selector shaft item Transmission housing and selector mechanism, removing and installing to cover plate
- Always replace
10 - O-ring
- Always replace
- Insert in groove in cover plate
11 - Locking bolt, 15 Nm
- For selector shaft gate
- Always replace
- Insert with locking fluid D 000 600 A2
12 - Hex bolt, 25 Nm plus 1/8 turn (45 ° ) further
- With attached washer
- Always replace
13 - Hex bolt, 25 Nm plus 1/8 turn (45 ° ) further
- Without washer
- Always replace
14 - Selector shaft
- Disassembling and assembling. Refer to Transmission selector mechanism, disassembling and assembling , Selector mechanism, disassembling and assembling
15 - Hex bolt, 20 Nm
- Always replace
16 - Selector mechanism cover
- Disassembling and assembling. Refer to Transmission selector mechanism, disassembling and assembling , Selector mechanism, disassembling and assembling
17 - Clutch housing
- Servicing. Refer to Clutch housing, servicing
18 - Transmission housing
- Servicing. Refer to Transmission housing, servicing