Shift Lever And Shift Lever Housing, Servicing: Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Lubricate all mountings and sliding surfaces with Polyurea grease Part No. G 000 450 02.
1 - Circlip
- Removing and installing. See Figure
2 - Bushing
3 - Spring
4 - Bushing
5 - Torx screw, 5 Nm
6 - Cover plate
7 - Damper
8 - Bearing shell
9 - Gear shift guide
10 - Damping washer
11 - Gasket
- Between shift housing and floor
- Self-adhesive
- Bond to shift lever housing
12 - Transmission shift lever
13 - Damper
14 - Shift housing
15 - Bushing
16 - Bolt, 25 Nm
17 - Fulcrum pin
18 - Guide bushing
19 - Spring
- Installing. See Figure
20 - Gate selector bracket
21 - Torx screw, 5 Nm
22 - Base plate
- Open tabs to remove
- Replace
23 - Lock washer
24 - Gate selector cable
- On gate selector bracket
- Installed position. Refer to Installed position of gear selector mechanism
25 - Gear selector cable
- Press onto gear shift guide
- Installed position. Refer to Installed position of gear selector mechanism
26 - Hex nut, 25 Nm
27 - Bushing
- Only installs in one position
28 - Lock washer