Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in the reverse sequence. When installing note the following:

Fig 1: Identifying Retainer & Clutch Master Cylinder Operating Rod

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Retainer -A- must be on clutch master cylinder operating rod -B-.
Pull piston rod out of master cylinder slightly and hold using a pair of pliers. Avoid damage to piston rod.
Push clutch pedal in direction of arrow to engage it, and make sure it is located correctly.

Fig 2: Installing Stop For Clutch Pedal Again

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install stop -A- for clutch pedal again.

Installed position:

Arm (arrow) points toward master cylinder -B-.

After installing clutch master cylinder, bleed clutch system. Refer to Clutch system, bleeding .