Diagnostic Mode 09: Vehicle information
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2001 Volkswagen Jetta, 2000 Volkswagen Jetta, 2000 Volkswagen Golf, 2000 Volkswagen GTI, and 1999 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- For all calibration and immobilizer information. Refer to the EBAHN-Website.
Diagnostic Mode 09 is used to display vehicle specific information, e.g. the different Engine Control Module (ECM) versions.
NOTE:
- Depending on scan tool and protocol used, diagnostic mode 09 and the information provided may be referred to by a different name.
Test requirement
- No DTCs stored in the DTC memory.
Procedure
- Connect the scan tool.
- Switch the ignition on.
- Select "Mode 09: Vehicle information".
- Select the desired "Test-ID".
- The information requested will be displayed on the scan tool screen.
The following table is a numerical list of all "Test-IDs" that may be selected.
| Test-ID | Diagnostic text |
| 02: | Vehicle identification number e.g. |
|
|
| 04: | Calibration identification e.g. |
|
|
|
|
| 06: | CVN (check sum) e.g. |
|
|
|
- Switch the ignition off.
End of procedure