Test-ID 01 ($01): Catalytic Conversion (Bank 1)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2001 Volkswagen Jetta, 2000 Volkswagen Jetta, 2000 Volkswagen Golf, 2000 Volkswagen GTI, and 1999 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the scan tool.
- Start the engine and run at idle.
- Select "Mode 6".
Select "Test-ID 01 ($01) ".
- Select the desired "Test-ID (TID)" or "Hex-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
| 05 ($05) | P0422 | Conversion Capability (storage) Check. For additional information, refer to the Bosch Motronic M 5.9.2 OBD System Strategy. Page 3. | --- | > 0.8 | Refer to DTC P0422 in the OBD DTC Summary Table for all monitoring values. ADDITIONAL EXHAUST REGULATION . |
| 07 ($07) | P0422 | Conversion Capability (storage) Check. For additional information, refer to the Bosch Motronic M 5.9.2 OBD System Strategy. Page 3 | --- | > 0.8 | Refer to DTC P0422 in the OBD DTC Summary Table for all monitoring values. ADDITIONAL EXHAUST REGULATION . |
| 08 ($08) | P0422 | Conversion Capability (storage) Check. For additional information, refer to the Bosch Motronic M 5.9.2 OBD System Strategy. Page 3 | --- | > 0.8 | Refer to DTC P0422 in the OBD DTC Summary Table for all monitoring values. ADDITIONAL EXHAUST REGULATION . |
- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure → Mode 03: Interrogating fault memory .
- Switch the ignition off.
End of diagnosis