Cylinder head cover, removing and installing: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, 2003 Volkswagen Jetta, and 2003 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse sequence ; note the following points:
NOTE:
- Replace cylinder head cover if damaged or leaking.
- First bolt intake manifold to cylinder head. Then tighten both bolts of the manifold support.
- Ensure tight fit of fuel hoses.
- If necessary replenish coolant → Cooling system, draining and filling .
- Check DTC memory: → 01 ON BOARD DIAGNOSTIC (OBD)
- Adapting engine control module to throttle valve control module: → 24 MULTIPORT FUEL INJECTION (MFI)
- Perform work sequence "Procedure after interrupting voltage supply" : → 24 MULTIPORT FUEL INJECTION (MFI)
- Read readiness code: → 01 ON BOARD DIAGNOSTIC (OBD)
- If DTC memory has been erased or engine control module separated from permanent positive supply, readiness code must be generated again: → 01 ON BOARD DIAGNOSTIC (OBD)