Installing sensor wheel to crankshaft
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, 2003 Volkswagen Jetta, and 2003 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Torque wrench (5-50 Nm) VAG 1331
- D 000 600 A2 Locking compound
Work sequence
Make sure crankshaft/sensor wheel contact surfaces are free of oil and grease.
- Apply a thin coat of locking compound D 000 600 A2 to contact surfaces of crankshaft and sensor wheel for additional security.
- Check that when installing "VR6" - arrow - is marked at individual threaded holes.
- Tighten all new securing bolts lightly by hand.
- Tighten securing bolt - 1 - to 10 Nm plus additional 90 ° (1/4 turn).
- Tighten securing bolts - 2 - to 10 Nm plus additional 90 ° (1/4 turn).