Engine and transmission supports, aligning

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Volkswagen Jetta, 2002 Volkswagen GTI, 2001 Volkswagen Jetta, 2001 Volkswagen GTI, and 2000 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Before loosening the bolts the assembly must be secured with engine support bridge 10-222 A.

Fig 1: Measuring Engine Mounting

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Engine support

a = 14.0 mm
b = 10.0 mm minimum
Both bolt heads must terminate flush with edge - c -.

Fig 2: Transmission Mount Dimensions

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Transmission support

Edges - a - and - b - must be parallel to each other.

NOTE:

Tightening torque, assembly support, refer to Engine and transmission mounts .