Checking resistance of solenoid valves
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen R32, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Re-connect 12-pin connector.
- Connect test box to control module wiring harness. Refer to Test box, connecting for wiring test
- Measure resistance of solenoid valves at test box between sockets:
| Component | Sockets | Specified value Ω |
| Solenoid Valve 1 -N88- | 55+67 | 55.0 to 65.0 |
| Solenoid Valve 2 -N89- | 54+67 | 55.0 to 65.0 |
| Solenoid Valve 3 -N90- | 9+67 | 55.0 to 65.0 |
| Solenoid Valve 4 -N91- | 47+67 | 4.5 to 6.5 |
| Solenoid Valve 5 -N92- | 56+67 | 55.0 to 65.0 |
| Solenoid Valve 6 -N93- | 22+58 | 4.5 to 6.5 |
| Solenoid Valve 7 -N94- | 10+67 | 55.0 to 65.0 |
NOTE:
Resistance value is valid at approx. 20 ° C. At higher temperatures, resistance value increases.
If one of the specified values is not obtained:
- Check wires to Transmission Control Module (TCM) according to wiring diagram. Refer to Checking wires to Transmission Control Module (TCM) .