Muffler with mountings, assembly overview: Notes
WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.
1 - Double clamp, 40 Nm
- Note installed position: Installed location of double clamp, in driving direction under Muffler with mountings, assembly overview
2 - Connection support
3 - M6 - 10 Nm, M8 - 25 Nm, M10 - 40 Nm
4 - Retaining ring
- Grey color identification
- Replace if damaged
5 - Front muffler
- Note installation position Aligning the exhaust system
6 - Suspended mount
- With retaining ring
- Replace if damaged
7 - Exhaust tailpipe
8 - Clamp, 40 Nm
9 - Rear muffler
- Installing muffler free of tension
10 - M6 - 10 Nm, M8 - 25 Nm, M10 - 40 Nm
11 - To vacuum control module
- Installed location behind left rear wheel housing
- Individual components Installed location of vacuum control module under Muffler with mountings, assembly overview
12 - Vacuum actuator
- Use hand vacuum pump VAS 6213 to check operation
13 - Retaining ring
- Red color identification
- Replace if damaged