Cruise control system - 1.9L TDI, activating
If a Diesel Direct Injection Engine Control Module (ECM) has been replaced, it may be necessary to activate the cruise control function in the new ECM. Check system status and activate/deactivate system using the following procedure:
- Connect VAG 1551/1552 Scan Tool. Refer to VAG 1551 Scan Tool (ST), connecting and selecting functions .
- Switch on ignition.
- Press buttons -0- and -1- to select Address word 01: "Engine electronics".
Display (example only)
| 038906018M 1,9l R4 EDC G00SG 0602 → Coding 00001 WSC XXXXX |
- If top line of display shows "G00SG", cruise control is activated.
- If top line of display shows "00SG", cruise control is not activated.
- To begin activation sequence press → button.
Display will appear as shown
| Rapid data transfer HELP Select function XX |
- Press buttons -1- and -1- to select function 11 "Login procedure"
Display will appear as shown
| Rapid data transfer Q 11 - Login procedure |
- Press -Q- button to enter input.
Display will appear as shown
| Login procedure Input Code Number XXXXX |
- To activate cruise control, enter code number 11463
- To deactivate cruise control, enter code number 16167
- Press -Q- button to enter input.
- End output (function 06) and perform test drive to confirm cruise control functions.