Lock cylinder, removing and installing: Installing

• Insert ignition key in lock cylinder and turn to position "Drive".
• Release securing lever using wire (approx. Ø 1.2 mm) and insert lock cylinder in steering lock housing.

NOTE: Where applicable, ensure immobilizer induction coil electrical connection orientation in lock cylinder housing guide.

• Pull wire out of lock cylinder and ensure lock cylinder is secured properly in steering lock housing.

Fig 1: Locating Electrical Connection For The Induction Coil For Anti-Theft Immobilizer

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Where applicable, reconnect immobilizer reading coil electrical connector -arrow- to lock cylinder.
• Install steering column switches and steering wheel. Refer to Steering column switches, removing and installing  .
• Reconnect battery. Refer to Battery with fastened fuse holder, disconnecting and reconnecting  .