Side mounted turn signals, removing and installing

Removing:

CAUTION:

Removal of turn signal lense/housing is only possible in one direction. The side of the housing equipped with retainer clip is not obvious in it's installed position. Use care when removing to prevent damage to retainer clip or housing.

CAUTION:

Before beginning repairs on the electrical system:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Apply suitable tape in area of lamp in order to protect paintwork.

Fig 1: Identifying Turn Signal Mounting Position Side & Spring Clip

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press turn signal with a suitable tool on the mounting position side -1- carefully in direction of arrow against the force of the spring clip -2- on the opposite side and lever out.
Pull rubber holder with push-fit bulb off bulb housing.
Pull push-fit bulb (12 V/5 W) out of housing (do not turn).

Installing:

Fit rubber holder with push-fit bulb onto bulb housing and insert into fender opening.
Check side turn signal (bulb) function.