Installed Position of the Inner Race, the Outer Race and the 1st Gear Synchronizer Ring
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Modified 1st Gear Synchronization Components (From Transmission Build Date 02 05 0)
-- Place the inner race -A- on the drive gear for 1st gear.
The angled tabs -arrows 1- face the outer race -B-.
-- Install the outer race -B-.
The tabs -arrows 2- must lock into the retainers -arrows 3- in the gear.
-- Install the synchronizer ring -C-.
The retainers -arrows 4- lock in the tabs -arrows 1- on the inner race -A-.
NOTE:
If the parts are not to be replaced, make sure they are reallocated to their original gear.