Fuel Level Sensor -G-

WARNING: This page is about a different car, the 2010 Volkswagen Jetta and 2009 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Observe the safety precautions when working on the fuel supply system. Refer to SAFETY PRECAUTIONS .
Observe the rules for cleanliness. Refer to CLEAN WORKING CONDITIONS .

Always follow these instructions before and during work.

Removing

-- Remove the fuel delivery unit. Refer to FUEL DELIVERY UNIT .

-- Disengage the wire connectors -1 and 2- and disconnect.

Fig 1: Identifying Connectors & Retaining Tabs/Lugs

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lift the retaining tabs -3 and 4- with a screwdriver and pull the fuel level sensor downward and off -arrow-.

Installing

-- Insert the fuel level sensor in the guides on the fuel delivery unit and push upward until it engages.

-- Connect the connectors and check for secure locking.

-- Install the fuel delivery unit. Refer to FUEL DELIVERY UNIT .