EVAP Canister

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the cover -A-.

Fig 1: Removing Cover

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Vehicles with Engine Codes BGP and CBTA:

-- Disconnect the lines -1, 2 and 3-. To do so, press in or press together the securing ring.

Fig 2: Disconnect Evaporative Emissions (EVAP) Canister Lines (Vehicles With Engine Code BGP)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the locking mechanisms on the bolt points in the -direction of the arrow- using a screwdriver and remove the Evaporative Emission (EVAP) canister -4-.

Vehicles with Engine Codes BGQ and CBUA:

-- Perform the removal the same way as on vehicles with engine codes BGP and CBTA.

Fig 3: Disconnect Evaporative Emissions (EVAP) Canister Lines (Vehicles With Engine Code BGQ)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installing

Installation is performed in the reverse order of removal. When doing this note the following:

Connect the ventilation lines until they engage audibly.
Make sure the lines and EVAP canister are locked securely.

Tightening Specifications

Component		Nm
EVAP canister to body		8