Vehicle alignment work procedure, overview
The work steps must be performed in the following sequence!
1 - Check front axle camber and adjust if necessary → Front axle camber, adjusting
2 - Check rear axle camber.
- Vehicles with front wheel drive: Camber is not adjustable, Notes → Camber on rear axle (vehicles front wheel drive), adjusting
- Vehicles with all-wheel drive: Notes → Camber on rear axle (vehicles with all-wheel drive), adjusting
3 - Check rear axle toe and adjust if necessary.
Vehicles with front wheel drive
The rear axle toe is not adjustable. → Toe on rear axle (vehicles front wheel drive), adjusting
Vehicles with all-wheel drive
Toe is adjustable. Adjusting toe, → Toe on rear axle (vehicles with all-wheel drive), adjusting
4 - Check front axle toe angle and adjust if necessary
5 - Check which suspension is installed in the vehicle. This information is found on the vehicle data sticker,