Test Requirements:

• Check suspension, wheel bearing, steering and steering linkage for excessive play and damage.
• Tread depth difference of no more than 2 mm on an axle.
• Tires inflated to correct pressure
• Vehicle unladen

Fuel tank must be full

Spare wheel and vehicle tools are stowed at correct installation locations?

The fluid reservoir for the windscreen/headlight washer system must be full.

• Ensure that the sliding plates and turn tables are not touching the end stop when checking the wheel alignment.

CAUTION!

• The test equipment must be properly adjusted and attached to the vehicle; observe device manufacturers operating instructions.

Apply to the manufacturer of your vehicle alignment equipment for training as and when required.

Vehicle alignment platforms and vehicle alignment units/vehicle alignment computers can lose their calibration over a period of time.

Vehicle alignment platforms and vehicle alignment units/vehicle alignment computers should be checked and if necessary adjusted within the framework of an inspection/maintenance at least once a year! 

• Treat these highly sensitive units carefully and conscientiously!