Torque specification:

50 Nm + 60 ° additional turn 

• To tighten 12-point nut we recommend the angle measuring wrench V.A.G 1756.

If an angle measuring wrench is not available, then tighten 12-point nut using following method.

• Lower vehicle until the wheels touch ground.
• Tighten 12-point nut to 200 Nm and loosen 1/2 turn.
• Pre-tighten 12-point nut to 50 Nm.

Fig 1: Identifying One Of The 12-Points On The Nut And The Edge Of The Wheel Hub Marked With A Line

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Mark one of the 12-points on the nut with a line - arrow A  -.
• Mark 2nd line - arrow B  - on the edge of the wheel hub as shown in illustration.
• Turn 12-point nut until both points align.