Cylinder head, removing and installing: Removing

WARNING: This page is about a different variant/trim than selected.

NOTE:

Both lifting eyes for the engine support bridge are located on the cylinder head, for that reason an additional holder to support the engine must be secured on cylinder block.

Fig 1: Identifying Bracket T10014

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fasten engine support T10014 as illustrated into threaded hole of cylinder block in area of coolant pump. Torque specification: 20 Nm.
Using spindle - A - , lift engine slightly until spindle - B - is unloaded.
Remove spindle - B -.

Fig 2: Identifying Cylinder Head Bolts Loosening Sequence

Courtesy of VOLKSWAGEN UNITED STATES, INC.