LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2000 >> Golf GLS, 1.8 B, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (2.0L - Engine Mechanical - AEG, AVH, AZG, BBW, BEV (A4 Platform)) >> 13 Engine - Crankshaft, Cylinder block >> Crankshaft, removing and installing >> Crankshaft, removing and installing >> Upper crankshaft bearing identification (gradual introduction)

Upper crankshaft bearing identification (gradual introduction)

WARNING: This page is about a different variant/trim than selected.
Fig 1: Upper Crankshaft Bearing Identification
GW00000048Courtesy of VOLKSWAGEN UNITED STATES, INC.

In the factory the upper bearing caps are determined with the correct thickness for the cylinder block. Colored marks are used to identify the thickness of the bearing shells. Refer to Color markings  .

Which thickness of shell should be installed to which location is marked by a letter on the lower sealing surface of the cylinder block -x-.

Arrow indicates direction of travel (forward).

scientia non olet · About LEMON Manuals