Installing Oil Seal For Right Flange Shaft
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Drive in new seal to stop of thrust piece, taking care not to cant seal.
- Moisten sealing lips of oil seal with ATF.
- Insert flange shaft.
- Apply sealant D 176 404 A2 to tapered section of countersunk bolt.
- Tighten countersunk bolt.
- Install right drive axle to flange shaft.
- Finally, check ATF level and top off, refer to ATF level, checking and topping off .
- Install noise insulation tray.