Installing Oil Seal For Left Flange Shaft
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Drive in new seal to stop, taking care not to cant seal.
- Moisten sealing lips of oil seal with ATF.
- Insert flange shaft.
- Apply sealant D 176 404 A2 to tapered section of countersunk bolt.
- Tighten countersunk bolt.
- Install left drive axle to flange shaft.
- Bolt swivel joint to suspension link in its original position.
- Install wheel.
- Finally, check ATF level and top off, refer to ATF level, checking and topping off .
- Install noise insulation tray.