LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2000 >> Golf GLS, 1.8 B, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (6 SPD. Manual Transmission 02Y All Wheel Drive) >> 39R - Final drive, rear differential >> Shaft and head bevel gear (gear set), adjusting >> Shaft bevel gear, adjusting >> Performing check measurement - checking dimension "r"

Performing check measurement - checking dimension "r"

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Insert universal mandrel and measure dimension "r".

If adjustment shims were determined correctly, dial indicator must indicate the determined dimension "r" with a tolerance of + 0.04 mm (reading counterclockwise in red number display).

scientia non olet · About LEMON Manuals