Seals for flanged shafts on rear final drive, replacing: Removing

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Remove left drive axle from flange and tie securely at lower lateral control arm.
Remove right drive axle from flange and tie securely between upper and lower lateral control arms.
Place appropriate receptacle underneath transmission.

Fig 1: Removing Flanged Shaft By Threading Lower Support Of Puller T10037 Into Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove flanged shaft by threading lower support of puller T10037 into housing - arrow -.
Pry out O-ring with a lever.