Left flanged shaft seal, replacing: Installing

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Driving Left Flanged Shaft Seal In Onto Stop

GW00001732

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drive in new seal to stop, without canting seal.
Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1.
Insert flanged shaft.
Secure flanged shaft with conical head bolt and tighten to specified torque.

Bolt ball joint and control arm to old impression marks using new bolts → 40 FRONT SUSPENSION .
Install left drive axle on flanged shaft → 40 FRONT SUSPENSION .
Install wheel → 44 WHEELS, TIRES, WHEEL ALIGNMENT .
Check gear oil in manual transmission with bevel gear transfer case → Gear oil, checking .

Install sound insulation, if present. → 66 EXTERIOR EQUIPMENT