Pulling off inner race/tapered roller bearing

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pulling Off Tapered Roller Bearing Inner Race

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove circlip beforehand.
Before attaching extractor, place thrust piece VW 431 and thrust plate 40-105 on output shaft.

Fig 1: Pulling Off Tapered Roller Bearing Inner Race

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Before installing puller, set thrust piece 30-11 onto output shaft.