Pulling off grooved ball bearing
WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.
- Beforehand, remove circlip from input shaft.
- Before attaching extractor, place thrust piece VW 431 and thrust plate 40-105 on input shaft.
- Attach separating device - B - into surrounding groove for circlip in bearing.
A - Extractor , e.g. Kukko 18/1
B - Separating device 12 to 75 mm , e.g. Kukko 17/1