Haldex Clutch Pump -V181- , removing and installing: Removing

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Switch ignition off.

Fig 1: Identifying Rear Driveshaft Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unbolt rear driveshaft with flexible disc and vibration dampener from rear final drive - arrow - and carefully press forward → Driveshaft .

Fig 2: Identifying Haldex Clutch Pump & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect connector for Haldex clutch pump - arrow 1 -.
Place appropriate receptacle underneath final drive.
Remove bolts - arrows 2 -.
Afterward, rotate pump slightly toward right.

Fig 3: Removing Pump Using Special Tools VW 771 & VW 771/37

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove pump direction of - arrow -.