Tightening torques
WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.
| Bevel gear transfer case to manual transmission. Always replace bolt | 40 Nm +45 ° | |
Flexible disc with heat shield to flange / bevel gear transfer case
Installing transmission carrier bevel gear transfer case/engine free of tension
Note the following sequence when installing the transmission carrier:
- Screw in all bolts hand-tight.
- Tighten bolts - B - (M10 x 22) first to 10 Nm.
- Tighten bolts - A - (M10 x 50) to 50 Nm.
- Tighten bolts to - B - to 40 Nm.