Valve guides, replacing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Volkswagen Jetta, 2002 Volkswagen GTI, 2001 Volkswagen Jetta, 2001 Volkswagen GTI, and 2000 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Coat new guides with oil and press them up to sleeve into cold cylinder head. Cylinder head must be lying flat during this procedure.

NOTE:

After the guide is in place with the sleeve, the pressure of pressing down cannot exceed 1.0 t, otherwise the sleeve might break off.

Ream valve guide with hand reamer 3120. Use diluted soluble oil during this procedure.
Rework valve seats, refer to Valve seats, reworking .