Camshafts, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Volkswagen Jetta, 2002 Volkswagen GTI, 2001 Volkswagen Jetta, 2001 Volkswagen GTI, and 2000 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Crankshaft Aligned With TDC Cyl. 1 Position

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Turn camshaft in engine turning direction to marker TDC cyl. 1 - arrow - at vibration damper retainer bolt.
Remove ignition coil N152.
Remove camshaft roller chain tensioner.
Remove cover.

Loosen fastening screws at camshaft sprockets.

Fig 2: Identifying Counterhold Area On Camshaft

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

Use only an open end wrench to counterhold against camshaft - arrow -. The camshaft ruler 3268 must not be inserted when tightening or loosening the sprockets.

Remove camshaft sprockets.

Fig 3: Camshaft Cylinder Row Assignments

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Camshaft, cylinder row 1, 3 and 5

Remove bearing covers 1 and 7 first.
Loosen bearing covers 3 and 5 in an alternating and crosswise pattern.

Camshaft, cylinder row 2, 4 and 6

Remove bearing cover 4 first.
Loosen bearing covers 2 and 6 in an alternating and crosswise pattern.