Cylinder head cover, removing and installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Volkswagen Jetta, 2002 Volkswagen GTI, 2001 Volkswagen Jetta, 2001 Volkswagen GTI, and 2000 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

The installation takes place in the reverse order.

NOTE:

If damaged or leaking, replace cylinder head cover.
First, screw the upper intake manifold to the lower intake manifold, then tighten both manifold support screws.
Make sure the fuel hoses are firmly connected.

If necessary, refill coolant, refer to Coolant, draining and filling .
Check DTC memory. Refer to 01 ON BOARD DIAGNOSTIC (OBD)
Adjust basic settings. Refer to 24 MULTIPORT FUEL INJECTION (MFI)
Check readiness code. Refer to 01 ON BOARD DIAGNOSTIC (OBD)

If Diagnostic Trouble Code (DTC) memory was erased or engine control module was disconnected from positive continuous voltage feed, regenerate readiness code: Refer to 01 ON BOARD DIAGNOSTIC (OBD)