Oil seal on vibration damper end of crankshaft, replacing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Volkswagen Jetta, 2002 Volkswagen GTI, 2001 Volkswagen Jetta, 2001 Volkswagen GTI, and 2000 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Lightly coat sealing lip of seal with oil.

Fig 1: Guide Sleeve From Sealer Installer 3266

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Place guide sleeve from Sealer installer 3266 on crankshaft nose.
Push oil seal over guide sleeve.

Fig 2: Sealer Installer 3266

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press seal in with pressure sleeve from Sealer installer 3266 until it reaches stop. Use old mounting bolt for vibration damper.

Fig 3: Vibration Damper Locked In Position With Counter Hold 3406

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install vibration damper and lock in place using counter hold 3406.
Tighten new mounting bolt to 100 Nm and turn an additional 1/4 turn (90 ° ).
Install "V" ribbed belt, refer to Ribbed V-belt, removing and installing .