Installing pulse-generating wheel on crankshaft
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Volkswagen Jetta, 2002 Volkswagen GTI, 2001 Volkswagen Jetta, 2001 Volkswagen GTI, and 2000 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Make sure the crankshaft to pulse-generating wheel connecting surface is free of oil and grease.
- To provide additional fastening, apply a light coat of adhesive D 000 600 to back of pulse-generating wheel.
- Make sure that marker -VR6- - arrow - is aligned with single threaded bore.
- Lightly tighten all fastening screws by hand.
- Tighten fastening screws to 10 Nm plus 1 / 4 turn (90 ° ).