Oil seal (flywheel side), removing and installing

WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Pulling Fixture T10122

GW00000440

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pulling fixture T10122

Fig 2: Extractor Hook T20143

GW00000441

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Extractor hook T20143

Removing

Fig 3: Placing Removal Hook T20143/2 Behind Sealing Lip Of Oil Seal

GW00000442

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Place removal hook T20143/2 behind sealing lip of oil seal as shown in the illustration.
Support removal hook T20143/2 on sealing flange and pry out oil seal in - direction of arrow -.

Installing

Fig 4: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

GW00000443

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull seal - A - with outer side over sleeve T10122/1 onto assembly tool T10122/2.
Separate both assembly sleeves.
Place assembly tool T10122/2 with dry seal onto crankshaft flange.

Fig 5: Driving Seal Into Sealing Flange Until Stop Using Thrust Piece T10122/3

GW00000444

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drive seal into sealing flange until stop using thrust piece T10122/3.