Pressing off 3rd gear (3GR)/4th gear (4GR) synchro-hub with operating sleeve, 2nd gear, 3rd gear (3GR) and 4th gear (4GR) with transmission housing needle roller bearing sleeve

WARNING: This page is about a different car, the 1999 Volkswagen GTI, 1998 Volkswagen GTI, 1997 Volkswagen GTI, 1996 Volkswagen GTI, and 1995 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

- Separator, 22-115 mm e.g. Kukko 17/2
- 17 mm hex -head bolt (M10 x 20)
NOTE: Support the separator tool so that the 1st/2nd gear operating sleeve stays in position and is NOT pulled off.

Fig 1: Pressing Off 3rd Gear/4th Gear Synchro-Hub With Operating Sleeve

Courtesy of VOLKSWAGEN OF AMERICA, INC.