Crash sensor for side airbag, driver's and front passenger side, removing and installing: Notes
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 1999 Volkswagen Jetta, 1999 Volkswagen Golf, 1999 Volkswagen GTI, 1998 Volkswagen Jetta, and 1998 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following list refers to Fig 1
.
- - Crash sensor for side airbag, driver's and passenger side
- - Connector
- - Bolt
- 10 N.m (89 ft. lb)
- - Carpet
- - Cover
- Disconnect battery Ground (GND) strap.
- Remove driver's or front passenger seat.
- Release carpet - 4 - and insulation mat in area of sensor.
- Pry off cover - 5 -.
- Disconnect connector - 2 - and remove screws - 3 -.