Turbocharger with attachments: Notes

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Observe safety precautions. Refer to Safety precautions .

Observe rules for cleanliness. Refer to Rules for cleanliness .

NOTE:

Hose connections are secured by clamps and retaining clips.

Fig 1: Spring-Type Clip Pliers VAS 5024A

Courtesy of VOLKSWAGEN UNITED STATES, INC.

The spring-type clip pliers VAS 5024A are recommended for installing spring-type clips.
Do not install hose connections with lubricants containing oil.
Charge air system must be properly sealed.
Before screwing on oil supply line, fill turbocharger with engine oil at filler tube.

After installing turbocharger, let engine run at idle for approx. 1 minute and without increasing engine speed. This ensures that charger is lubricated.
Replace self-locking nuts.