Vehicles with front wheel drive (FWD): Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
1 - Filler cap
2 - Oil seal
- Replace if damaged
3 - Bolt
4 - Tank flap unit
- With rubber cup
5 - Ground (GND) connection
6 - O-ring
- Always replace
7 - Breather valve
- To remove valve unclip sideways out of support
- Before installing remove sealing cap
- Checking Checking breather valve
8 - 10 Nm
9 - Vent line
- Ensure seated tightly
10 - Lock washer
11 - Heat shield
12 - Cover for fuel tank
13 - 25 Nm
14 - Securing strap
- Observe varying lengths
15 - Fuel tank
- Support with engine/transmission jack V.A.G 1383 A when removing
- Removing and installing. Refer to Fuel tank, removing and installing
16 - Oil seal
- Replace if damaged
- To install, place into opening of fuel tank dry
- Moisten with fuel only when installing flange
17 - Sender for fuel gauge
- Note installed position on fuel tank Installed location of the fuel gauge sender
18 - Union nut
- Use ring nut wrench 3217 for removal and installation
19 - Supply line
- To fuel filter. Refer to Fuel filter, assembly overview
- Clipped in at fuel tank
- Ensure seated tightly
- Black
- To remove from flange, press release buttons on connecting piece
20 - Return line
- From fuel filter. Refer to Fuel filter, assembly overview
- At connection - R -
- Blue or with blue marking
- Clipped in at fuel tank
- Ensure seated tightly
- To remove from flange, press release buttons on connecting piece
21 - Gravity/expansion valve
- To remove valve unclip upward out of support
- Check valve for through-flow, Valve vertical: open, Valve angled at 45 ° : Closed
22 - Angle piece