Cylinder head, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Both lifting eyes for the engine support bridge are located on the cylinder head, for that reason an additional holder to support the engine must be secured on cylinder block.

Fig 1: Identifying Bracket T10014

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fasten engine support T10014 as illustrated into threaded hole of cylinder block in area of coolant pump. Torque specification: 20 Nm.
Using spindle - A - , lift engine slightly until spindle - B - is unloaded.
Remove spindle - B -.

Fig 2: Identifying Cylinder Head Bolts Loosening Sequence

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Follow sequence for loosening cylinder head bolts.