Crankshaft seal (ribbed belt side), replacing: Installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Phased in introduction of PTFE sealing rings (Distinguishing feature: without inner ring spring, sealing lip designed wider). The sealing lip of this sealing ring may not be oiled or greased. An oil seal of the old version (with inner ring spring) can be replaced by a PTFE seal - but not the other way around.

Installing PTFE-version seal.

Lightly oil sealing lip of seal.

Fig 1: Identifying Guide Sleeve 2080 A Mount On Crankshaft Journal

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install sleeve 2080 A onto crankshaft journal.
Push seal over guide sleeve.

Fig 2: Pressing Seal With Center Bolt Into Sealing Flange Using Seal Installer 3265

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Using seal installer 3265 , press seal with center bolt - 1 - approx. 2-3 mm deep into sealing flange.
Toothed belt, installing, tensioning. Refer to Toothed belt, removing, installing and tensioning .