Installing PTFE-version sealing ring

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do not oil or grease the sealing lip of the sealing ring.

Before installing, remove oil remains from crankshaft journal with a clean cloth.

Fig 1: Identifying Guide Sleeve From Assembly Tool T10053 & Crankshaft Journal

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Position guide sleeve from assembly tool T10053 on crankshaft journal.
Slide sealing ring over guide sleeve.

Fig 2: Pressing Oil Seal Using Assembly Tool T10053 And Bolt T10053/2

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press in oil seal using assembly tool T10053 and bolt T10053/2 (M16 x 1.5 x 60) up to stop.
Toothed belt, installing, tensioning. Refer to Toothed belt, removing, installing and tensioning .