EVAP system components, servicing, Vehicles up to 1995
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1999 Volkswagen Jetta, 1999 Volkswagen GTI, 1998 Volkswagen Jetta, 1998 Volkswagen GTI, and 1997 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following list refers to items in Fig 1
.
- - Vent pipe
- From gravity valve on fuel tank, See FUEL FILTER AND FUEL TANK WITH ATTACHMENTS, REMOVING AND INSTALLING , item -5-
- - 2 pin harness connector
- - Evaporative Emission (EVAP) Canister Purge Regulator valve (N80)
- Blue
- Normally open
- With engine warm, valve is activated (closed) by Motronic ECM -J220-
- Activation, checking:
- Function, checking. See EVAP canister purge regulator valve -N80-, checking (Vehicles up to 1995) .
- - Retaining ring
- - Bracket
- On Air Cleaner (ACL) Housing, lower
- - Intake manifold, upper
- - Vent hose
- Observe correct installation position. See Figure .
- - 10 Nm (7 ft lb)
- - Evaporative Emission (EVAP) Canister
- Location: right-front wheel housing
- Removing: first remove Air Cleaner (ACL) Housing and Mass Air Flow (MAF) Sensor -G70-
- Checking, see CHECKING EVAP CANISTER