Rear brake drums, removing and installing: Notes
WARNING:
- Do not re-use fasteners that are worn or deformed in normal use.
- Some fasteners are designed to be used only once, and are unreliable and may fail if used a second time. This includes, but is not limited to, nuts, bolts, washers, circlips and cotter pins. Always follow recommendations in this manual-replace these fasteners with new parts where indicated, and any other time it is deemed necessary by inspection.
The following list pertains to Fig 1.
- Grease cap
- Removing, see REMOVING GREASE CAP
- Installing, see INSTALLING GREASE CAP
- Cotter pin
- Always replace
- Lock ring
- Nut
- Adjusting wheel bearing play, see ADJUSTING WHEEL BEARING PLAY
- Thrust washer
- Outer wheel bearing
- ABS wheel speed sensor rotor
- Only on vehicles with ABS
- Removing and installing, see Removing ABS wheel speed sensor rotor
- Brake drum
- Clean thoroughly, check for wear, damage, damaged wheel bolt threads and dimensions
Vehicles with front wheel drive:
- Diameter: 200 mm (7.874 in.)
- Wear limit: 201 mm (7.913 in.)
- Clean thoroughly, check for wear, damage, damaged wheel bolt threads and dimensions
- Stub axle
- Socket-head bolt
- 10 N.m (7 ft lb)
- ABS wheel speed sensor
- Only on vehicles with ABS
- Before installing sensor, clean mounting hole inner surface and coat with lubricating paste, Part No. G 000 650
- Backing plate with brake shoes
- Release brake adjuster before removing brake drum
- Dished washer
- Large contact surface faces backing plate
- Hex bolt
- 60 N.m (44 ft lb)