VR6 vehicles m.y. 1996 and up: Removing

NOTE: If used pads are to be re-installed, first mark their original locations. Re-install pads to the same positions to avoid uneven braking.

Remove guide pin protective caps.

Fig 1: Removing Guide Pin Protective Caps (Teves/ATE Caliper)
Courtesy of VOLKSWAGEN OF AMERICA, INC.
Using screwdriver, pry off brake pad retaining spring from brake caliper (arrow), and remove spring.

Fig 2: Using Screwdriver To Pry Off Brake Pad Retaining Spring From Brake Caliper (Teves/ATE Caliper)
Courtesy of VOLKSWAGEN OF AMERICA, INC.
Remove both guide pins from brake caliper.

Fig 3: Removing Both Guide Pins From Brake Caliper (Teves/ATE Caliper)
Courtesy of VOLKSWAGEN OF AMERICA, INC.
Remove brake caliper and lay to one side or suspend from body with wire, and remove brake pads from brake caliper or from carrier.

CAUTION:

Do not allow the caliper to hang by the brake hose. The unsupported weight can stretch and damage the hose.
Do not disconnect the brake hose from the caliper when removing brake pads.